¿How to install Payment Terminal?
¿How to install Payment Terminal?
Instructional Guide for Waitry Payment Card Terminal Installation 💳
Once you have received your card terminal package: 📦 The package will arrive in a box, which will contain a cable and another smaller box with the card terminal inside.
IMPORTANT: Do not discard any of the received package wrapping until you are sure that you have received all the components.
What components should be included in the package? 🔌 Power supply 📱 P630 Plus Payment Terminal 🛜 Accessories based on the connection type, for example, an Ethernet adapter 🔰 Privacy Shield Plastic
¿How should I assemble the card terminal?
1- Open the cover on the back of the terminal, plug in the adapter cable, and close the cover.
2 - Tighten the cam-lock screw on the back cover (if present) to help prevent damage to the cable connector caused by pulling on the cable.
3 - Place the Privacy Shield (It is important to place it to protect the view when entering the PIN).
- Place the card terminal on its stand and lower the stand's cover so that the terminal is secured and cannot fall. **
2 - Feed the cable through the opening of the black tube located on the kiosk arm.
**3 - Loosen the screws on the bottom part of the kiosk arm and remove the cover. **
**4 - Insert the cable into the inner part of the kiosk arm. The end of the cable must come out through the small slot located on the left side of the arm. **
**5 - Put the cover back on and re-insert the screws. **
**6 - Open the kiosk using its key, from the right side of the kiosk. **
7 - Insert the cable, connect it to the power strip located inside the kiosk, and close the kiosk again.
¿How to Connect the Card Terminal to the Internet?
WIFI:
1 - Turn on the card terminal.
2 - Press 9999 and the green button.
3 - Enter the settings (If it asks for a password, it will be the one provided to you once your Waitry Payments account that has been registered).
4 - Connect it to your Wi-Fi network.
Ethernet: Connect an Ethernet cable to the port marked with ETH or this symbol 🌐 on the device.
**Autoboarding: **
Once the card terminal is connected to the internet, the terminal will begin updating to its latest version. This process may take between 15 and 30 minutes.
POWER ON / POWER OFF:
To turn On the Terminal: Connect the terminal to a power source. During startup, the screen will turn on and off several times.
To Restar the Terminal: Go to Settings and select Power.
Enter your access code. Select Restart and confirm.
To turn Off the Terminal:
Disconnect the terminal from the power source.
Accessing Payment History:
1 - Navigate to “Transactions”
2 - Select the “History” option (This allows you to view the transactions stored on the terminal. You can reprint the merchant or customer receipt for an approved transaction).
Updated on: 13/11/2025
Thank you!